Linksys ETHERFAST LNE100M - Manual (Page 9)

Instant EtherFast ® Series
4b. If you are using Windows
2000 or XP, the screen
shown in Figure 4-4 will
appear.
5. On this screen, you will need to type your computer’s name in the appro-
priate field. Then, click the Driver Install button to continue. Once the
driver is installed, the NIC Control Set will automatically be installed. This
NIC Control Set is a utility for managing the Adapter.
6. When installation is com-
plete, you will be asked
to restart your computer.
(See Figure 4-5.) Restart
your computer now.
Driver installation is complete!
Chapter 5: Manual Installation and
Setup for Windows 98SE
After physically installing the Adapter in your computer, follow these instruc-
tions to manually install the network device driver. The installation procedure
for the network driver will vary depending on which version of Windows 98
you are using, and on your current system configuration. If at any time during
the installation you encounter problems, refer to the Troubleshooting section.
1. Start up your PC in Windows 98.
2. Windows 98 will automatically detect the presence of the Adapter in your
PC.
3. Insert the Setup Utility CD into your CD-ROM drive while the Add New
Hardware Wizard window is visible. When the screen shown in Figure 5-1
appears, click the Next button.
Installing the Adapter’s Driver
Overview
Figure 5-1
10
Important: The directions in this Chapter only apply if you
have not already installed the drivers with the Setup Utility CD.
Figure 4-4
Figure 4-5
9
EtherFast ® 10/100 Managed Network Adapter