Linksys ETHERFAST LNE100M User Manual

Page 14

4. Click the Search for the best driver for your device (Recommended)

radio button and select Specify a location. Type D:\drivers in the drop-
down box and click the Next button.

5. A window will open, notifying you that Windows is searching for the

EtherFast 10/100 Managed Network Adapter driver. When the window noti-
fies you that it is ready to install the driver, as shown in Figure 6-3, click
the Next button.

Instant EtherFast

Series

Figure 6-2

Figure 6-3

Chapter 6: Manual Installation and

Setup for Windows Me

After physically installing the Adapter in your computer, follow these instruc-
tions to manually install the network device driver. If at any time during the
installation you encounter problems, consult the Troubleshooting section.

1. Start up your PC in Windows Me.

2. Windows Me will automatically detect the presence of the PCI Ethernet

Controller hardware in your PC.

3. Insert the Setup Utility CD into your CD-ROM drive while the Add New

Hardware Wizard window, shown in Figure 6-1, is visible. Click the Specify
the location of the driver (Advanced) radio button. Click the Next button.

Installing the Adapter’s Driver

Overview

Important: Do not click Cancel or Skip at any time during the installation.

Doing so will prevent your driver from being properly installed on your PC.

Figure 6-1

Important: The directions in this Chapter only apply if you

have not already installed the drivers with the Setup Utility CD.

EtherFast

10/100 Managed Network Adapter