Linksys ETHERFAST LNE100M User Manual
Page 45
Appendix E: Starting Over in
Windows 98, Me, 2000, or XP
If you experience installation difficulties, you may need to re-install all of the
Windows networking components. The instructions below explain how to give
your PC a clean sweep so that you can retry the Adapter’s driver installation.
1. From the desktop click on the Start Button, highlight Settings, and open
the Control Panel.
2. Double-click on the Network Icon. (See Figure E-1.)
3. If the Configuration box has a component called Dial-Up Adapter, skip for-
ward to step five. If it doesn’t, continue with step four.
Starting Over in Windows 98 or Me
82
Figure E-1
EtherFast
®
10/100 Managed Network Adapter
81
Instant EtherFast
®
Series
3. Optional: Click on the Access Control tab. Make sure that Share-level
access control is selected; do not choose User-level access control. If
Access Control is grayed out and cannot be selected, refer to the
Troubleshooting section.
4. When you’re done, click the OK button. When asked if you want to restart
your PC, do so.
The Windows Domain portion of the Windows setup is complete.