Linksys ETHERFAST LNE100M - Manual (Page 21)

3. When the list of available network adapters appears, as shown in Figure 7-
13, click
the Have
Disk but-
ton.
4. At the Insert Disk screen, shown in Figure 7-14, insert the Setup Utility
CD-ROM and type
D:\drivers\winnt
into the field on
your screen and
click the OK but-
ton.
5. Highlight the
EtherFast 10/100
Managed Network
Adapter Driver
entry in the window
that appears, shown
in Figure 7-15, and
click the OK but-
ton.
34
Figure 7-13
Figure 7-14
Figure 7-15
33
The following steps are for NT PCs that have networking already installed
according to the Windows NT documentation. If you have not already installed
networking onto your NT PC, please refer to your Windows documentation.
These steps will install the Adapter’s driver software on your PC, enabling your
PC to properly communicate with the Adapter. Remember that you must be
logged on as a network administrator to continue.
1. Click the Start button, and select Settings. Then, open the Control Panel,
and double-click on the Network icon.
2. When the networking window (shown in Figure 7-12) appears, choose the
Adapters tab and click the Add button.
Installing the Adapter’s Driver
if Networking is Already Installed
Instant EtherFast ® Series
Figure 7-12
EtherFast ® 10/100 Managed Network Adapter