Lifescan One Touch Basic Plus Diabetes Monitoring System - Manual (Page 26)

Step 2: Apply Control Solution.
Shake the control
solution vial well
before using. If there
are any bubbles on
the top of the vial,
wipe them off with a
clean tissue. Remove
the cap and apply a
drop of control solution to the
middle of the test spot, covering it
completely. Do not dab, wipe, or
smear control solution on the test
spot. Avoid contaminating the
control solution. Do not touch the
test spot with the tip of the vial.
Step 3: Control Solution Result
Appears in 45 Seconds.
Compare the control
solution test result
with the ONE TOUCH
™
Normal Control Range
printed on the test
strip vial. When you
get a control solution
test result within the
control range, you are
ready to test your blood.
M M C
(Example)
M M
Plus
ONE TOUCH ™ Normal Control Range
(Example)
19
Note: The control solution range is
shown in two different units of
measure—mg/dL and mmol/L.