Kenwood TK-7150 - Manual (Page 3)

TK-7150
3
5-2. Radio location
Select a convenient location for your control station radio
which is as close as practical to the antenna cable entry point.
Secondly, use your system’s power supply (which supplies
the voltage and current required for your system). Make sure
sufficient air can flow around the radio and power supply to
allow adequate cooling.
Merchandise received
License and frequency
allocated by FCC
Choose the type of transceiver
Frequency range RF power Type
136~174MHz 50W TK-7150 K
Are you using
the remote kit?
YES
KRK-9
Control cable KCT-22
M : 8 feet
M2 : 17 feet
M3 : 25 feet
Are you using
the key label?
Supplied key label
Are you using
the voice scrambler/
ANI?
Modified of control unit
Are you using
the ignition sense
cable?
KCT-18
Are you using
the noise-canceling micro-
phone?
KMC-28A
Supplied microphone
Delivery
Transceiver programming
DC power cable
Supplied cable or
KCT-23 M : 10 feet
KCT-23 M3 : 23 feet
Are you using
the external speaker?
Are you using
the keypad microphone?
YES
YES
YES
External speaker KES-5
YES
YES
KMC-27A
YES
NO
NO
NO
NO
NO
NO
NO
See page 5.
A personal computer (IBM PC or compatible), programming interface (KPG-46),
and programming software (KPG-79D) are required for programming.
See page 8.
See page 7.
See page 9.
See page 7.
See page 7.
DC power supply KPS-10A
Desk top microphone KMC-9C
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and align-
ment procedures contained in this manual.
GENERAL / SYSTEM SET-UP
SYSTEM SET-UP