Kyocera FS-1200 - Manual (Page 80)

4.1. Toner Kit Replacement
4-3
6. Install the toner container on the developer as shown
in the diagram.
☛
Be sure to peel off the seal on the toner container
before mounting the toner container on the devel-
oper unit.
7. When the toner container is installed correctly on
the developer. Push the top of the toner container
unit ("
PUSH HERE") until it locks in.
☛
Make sure that the toner container is properly
locked in the printer.
8. Close the top cover by pressing the arrowed part in
this diagram.
☛
It is necessary to clean the inside of the printer
after replacing the toner container.
If the toner container is replaced when the message
ý5HSODFH 7RQHUý&OHDQ SULQWHU is dis-
played, the message ý&OHDQýSULQWHUý3UHVVý&217,18( will be displayed after replacement.
After cleaning the inside of the printer (See Section 4.2. Cleaning), the message will disappear when
the
CONTINUE key is pressed, and the printer will be ready for printing.