KTM 1190 RC8 FR - Manual (Page 140)

MAINTENANCE WORK ON CHASSIS AND ENGINE
138
700271-12
– Position the brake calipers and check that the brake linings are seated correctly.
– Mount and tighten screws
 .
Guideline
Screw, front brake caliper M10x1.25 45 Nm
(33.2 lbf ft) Loctite ® 243™
– Operate the hand brake lever several times until the brake pads are lying correctly on
the brake disc.
– Take the front of the motorcycle off the work stand. ( S. 95)
– Take the rear of the motorcycle off the work stand. ( S. 96)
700272-11
– Pull the front brake and compress the fork powerfully a few times.
The fork legs straighten.
– Fully tighten screws  .
Guideline
Screw, fork stub M8 15 Nm (11.1 lbf ft)
9.45
Removing rear wheel
x
– Jack up the motorcycle rear end. ( S. 96)