Kathrein Twin-PVR Satellite UFS 821si - Manual (Page 95)

95
Installation Menu
Use the

buttons to select the tuner for which you want to make
the settings and confirm your menu selection by pressing the  button.
The settings for both tuners are made in the same way.
Tuner Settings
Select Satellite:
Use the
 buttons to select the satellite here.
Select Transponder:
Use the
 buttons to select the transponder here.
Motorised Antenna Setup:
Use the

buttons to select the control signal you want to use for
the motorised antenna here (DiSEqC™1.2, DiSEqC™1.3 (USALS) or
OFF for none).
Motor Control:
Use the
 buttons to select the command for the motorised antenna
here. You can choose between:
- Stop
- Save
- Set East Limit (Start rotation eastwards with
 button/step-by-step
eastwards with

)
- Set West Limit (Start rotation westwards with  button/step-by-step
westwards with  )
- Limits Off
- Reset
Action:
Press
 or choose “OK” to activate the “Stop”, “Save”, “Limits Off”
and “Reset” actions. You can also press the

/

button here to stop
ongoing rotations and save the current position.
The optimum setup is shown by
the signal strength and quality
bar charts at the bottom.
With the East/West limit you
can set the extreme stop points
(limited by a wall or other
obstacles) in the westward and
eastward directions.
Always read the operating
manual supplied by the
rotor/antenna manufacturer
thoroughly (particularly with
regard to settings different to
those described here).