Kathrein Twin-PVR Satellite UFS 821si - Manual (Page 92)

92
Select Transponder:
Press
 to call up a list of available stored transponders on the
satellite you previously selected. Use the  buttons to select
the transponder you want. If the transponder you want is not listed,
select the “Enter New Transponders” option. Press
 to save your
selection.
If you have selected an already stored transponder, skip the next points
and resume from “Network Search”.
Transponder Frequency (input field only active if “Enter New
Transponders” selected) :
Use the number pad on your remote control to key in the frequency of
the new transponder here.
Transponder Polarisation (input field only active if “Enter New
Transponders” selected) :
Use the  buttons to select the polarisation of the new transponder
here.
Symbol Rate (input field only active if “Enter New Transponders”
selected) :
Use the number pad on your remote control to key in the symbol rate of
the new transponder here.
At the bottom right you will see the signal strength of the transponder
on the two tuners, enabling you to check that the transponder data you
just entered is OK.
Network Search:
Use the
 buttons to select the setting for the network search.
Manual Search
Installation Menu