Kathrein Twin-PVR Satellite UFS 821si - Manual (Page 89)

89
Tuner 1 Setup
Installation Menu
Antenna Number:
Each tuner can receive from up to four satellites. Use the

buttons
to select the position to which you want to assign a new or different
satellite.
Satellite Name:
Press
 to access the list of available satellites. Select the satellite
you want using the  buttons and confirm your selection with  .
Make sure your reception system is aligned to the selected satellite.
LNB Frequency:
Use the

buttons to select the LNB frequency applicable to
your reception system or press

to view the same listing as on first
installation, containing the most common variants as follows.
- Single (LNB Low frequency 9750 MHz)
- Dual (LNB Low frequency 9750 MHz + LNB High frequency 10600
MHz)
- Universal (LNB Low frequency 9750 MHz + LNB High frequency
10600 MHz + Limit frequency 11700 MHz)
Use the  buttons to make your selection. To confirm your selection
use the  buttons to select “OK” and press  .
22kHz Control:
Use the
 buttons to make your selection (On/Off). The 22kHz
signal is needed to switch LNBs in multifeed reception and to switch
between Low and High band.