Kathrein Twin-PVR Satellite UFS 821si - Manual (Page 93)

93
Installation Menu
Transponder Frequency:
Use the number pad on your remote control to key in the frequency of
the transponder on which the channel you are searching for is located.
Transponder Polarisation:
Use the

buttons to select the polarisation of the transponder
here.
Symbol Rate:
Use the number pad on your remote control to key in the symbol rate of
the transponder here.
Advanced Channel Search
If you set the network search to “On”, the transponder network enables
additional transponders that have not yet been stored to be located.
They are then stored and scanned for new channels in the same way
as the existing transponders.
If you set the network search to “Off”, only the factory stored transponders
of the satellites you previously selected will be scanned for new as yet
unlisted channels.
FTA CA Select:
Use the
 buttons to select whether you want to search through all
channels or only FTA (Free to Air) or CA (Conditional Access) channels
(Common Interface “required”).
Start Search:
When you have made your selection, use the
 buttons to select
“Start Search” and press

to start searching.