Kathrein Twin-PVR Satellite UFS 821si - Manual (Page 18)

18
Transponder:
Use the
 buttons to scroll through the
transponders of the satellite highlighted in yellow at
the top of the display. At the right you will see the
signal strength of the transponder on the two tuners,
enabling you to check that the satellite configuration
you just set up is OK.
When you have finished configuring this satellite,
press

.
If in the preceding “Select Satellite” menu you
selected more than one satellite, you will now
see the configuration for the next of the satellites
you selected. Configure the satellite as described
above.
When you have finished configuring the satellite
press
 . The receiver then automatically calls up
the selection menu for the channel search.
First Installation
Transponder:
Use the
 buttons to scroll through the
transponders of the satellite highlighted in yellow at
the top of the display. At the right you will see the
signal strength of the transponder on the two tuners,
enabling you to check that the satellite configuration
you just set up is OK.
When you have finished configuring the satellite
press

.
If in the preceding “Select Satellite” menu you
selected more than one satellite, you will now
see the configuration for the next of the satellites
you selected. Configure the satellite as described
above.
When you have configured all the satellites you
previously selected for tuner 1, you see the satellite
configuration display for the second tuner (see
example screenshot):
Configure the satellites for the second tuner in the
same way as for tuner 1.
When you have finished configuring the satellite
press

. The receiver then automatically calls up
the selection menu for the channel search.
The notes on first installation are unified
once again from this point!