Kodak RP 50 2J0686 - Manual (Page 84)

Maintaining the Equipment
4-10 October 2002
Replacing Chemical and Wash Filters
Check the condition of the filters in the processor tanks. If necessary, replace
the filters.
NOTE: The filter for the developer is different than the filters for the other chemicals
and for the wash. It can be identified by a gray ring on its end. See “Supplies”
on page A-1.
Checking the Fittings for Leaks
Check all fittings for leaks. If necessary, tighten the fitting. Use a screwdriver to
tighten tube clamps.
CAUTION: Do not use tools to tighten the compression fittings. Use your
fingers to “finger tighten” these fittings.
chemical/
wash
filter