Kodak RP 50 2J0686 - Manual (Page 44)

System Operating Procedures
3-12 October 2002
CAUTION: If the paper does not load properly or a paper jam occurs,
press Cancel. Remove any paper from the shoe area and
repeat steps 6 through 12. Make sure the lead edge is cut
square.
13. Close the paper supply door. The paper automatically feeds into position for
printing and the fogged section at the lead edge of the roll is trimmed off. The
message “Status: ON LINE – Ready” appears when initialization is complete.
cassette
paper alignment
guide
gear on the
lead edge of
the paper
cassette
printer
gear on the
clamp
idler
roller