Kodak RP 50 2J0686 - Manual (Page 179)

October 2002 E-1
Appendix E: Using the PHOTOSHOP
Export Module
This appendix describes how to use the Export Module for PHOTOSHOP on
MACINTOSH Systems with the KODAK PROFESSIONAL RP 50 LED Printer.
The Export Module allows you to export prints from PHOTOSHOP to a KODAK
PROFESSIONAL 20P Printer.
The Export Module allows you to:
• Scale an image by 200%
• Center an image within a user specified border
Installing the Export Module
This section explains how to install the Export Module on your MACINTOSH
system. It assumes that you are familiar with the MACINTOSH System
Environment.
Hardware Requirements
The following hardware is required for the Export Module:
• 120 MHz PowerPC 601 Processor
• Minimum of 72 MB of RAM
• Hard disk space that is at least three times your image size
• A standard SCSI terminator if you are daisy-chaining your external disk drive
or other peripheral with the printer and you are not using a MACINTOSH IIfx
Computer
• An APPLE SCSI Terminator if you are using a MACINTOSH IIfx Computer
and you have an external SCSI disk drive or other
peripheral device
• KODAK PROFESSIONAL Printer
Software Requirements
The following must be installed on your MACINTOSH System:
• MACINTOSH System 7.5.5 or later
• ADOBE PHOTOSHOP, version 3.0 or later