Resetting the defaults, Resetting the parameters, Select “setup” from the main menu on the ocp – Kodak RP 50 2J0686 User Manual
Page 55: Select “defaults, Select “reset parameters to factory, Resetting the printing luts, Select “reset printing luts to factory, Resetting the copyright detection luts, Select “reset copyright luts to factory
System Operating Procedures
October 2002
3-23
Resetting the Defaults
Resetting the Parameters
This procedure resets the parameters of the printer to the factory setup (default)
values. To indicate that the values have been reset to the factory setup values, the
word “done” is displayed in parenthesis after “Reset Parameters To Factory” on
the menu.
NOTE: Diagnostic parameters are not reset by this action.
1.
Select “Setup” from the main menu on the OCP.
2. Select
“Defaults”.
3. Select “Reset Parameters to Factory”.
4. Select “Exit” to return to the previous menu on the OCP.
Resetting the Printing LUTs
This procedure resets the Printing LUTs stored in nvram to the factory setup
(default) values. To indicate that the values have been reset to the factory setup
values, the word “done” is displayed in parenthesis after “Reset Printing LUTs To
Factory” on the menu.
1.
Select “Setup” from the main menu on the OCP.
2. Select
“Defaults”.
3. Select “Reset Printing LUTs to Factory”.
4. Select “Exit” to return to the previous menu on the OCP.
Resetting the Copyright Detection LUTs
This procedure resets the Copyright Detection LUTs stored in nvram to the factory
setup (default) values. To indicate that the values have been reset to the factory
setup values, the word “done” is displayed in parenthesis after “Reset Copyright
LUTs To Factory” on the menu.
1.
Select “Setup” from the main menu on the OCP.
2. Select
“Defaults”.
3. Select “Reset Copyright LUTs to Factory”.
4. Select “Exit” to return to the previous menu on the OCP.