Selecting the target pad read options, Select “setup” from the main menu on the ocp, Select “ports – Kodak RP 50 2J0686 User Manual
Page 48: Select “scsi, Select “target pad reads, Press select to select/set the new value, Managing a modem, Resetting the modem port, Select “modem (diag), Select “reset port
System Operating Procedures
3-16
October 2002
Selecting the Target Pad Read Options
1.
Select “Setup” from the main menu on the OCP.
2. Select
“Ports”.
3. Select
“SCSI”.
4. Select “Target Pad Reads”.
5. Use
the
Up and Down Arrows to select “Yes” or “No” to indicate whether or
not the SCSI device driver will pad initiator read requests with zeros to the
requested length or terminate the SCSI read transaction when it has sent only
the data it has to send.
6. Press
Select to select/set the new value.
7. Select “Exit” to return to the previous menu on the OCP.
Managing a Modem
Resetting the Modem Port
1.
Select “Setup” from the main menu on the OCP.
2. Select
“Ports”.
3. Select “Modem (Diag)”.
4. Select “Reset Port”.
5. Select “Reset Modem Port Now”.
NOTE: This causes the modem port to be set to its original factory setting.
6. Select “Exit” to return to the previous menu on the OCP.
Checking for a Modem
NOTE: This causes the printer to query the modem port for the presence of a
modem.
1.
Select “Setup” from the main menu on the OCP.
2. Select
“Ports”.
3. Select “Modem (Diag)”.
4. Select “Check Presence”.
5. Select “Check Modem Presence Now”.
6. Select “Exit” to return to the previous menu on the OCP.