Kodak RP 50 2J0686 - Manual (Page 110)

Diagnostics and Troubleshooting
5-20 October 2002
Calibration Error Codes
Error
Code Error Code /Status
Message
Possible Cause/Subsystem Possible Solution
1 The following file is
locked:_filename_. The system is trying to access a
file that is currently in use. Close any other applications that
may be accessing the file.
2 The following file is
protected:_filename_. The system is trying to access a
file that is protected. Change the protections on the file
to grant access to the user.
3 The following file was not
found:_filename_. The system was trying to access
a file that it could not find. Verify that the filename on one of
the configuration dialog windows is
correct.
4 Error:_oserror_occurred
during operation:_operation_
on file:_filename_. An operating system error
occurred. • Rerun the application.
• Reboot the operating system
5 The following file is in an
incorrect format:_filename_. The file does not conform to the
application specification. Verify the file format.
6 The following file already
exists:_filename_. The system is trying to save to a
file that already exists. • Delete the existing file.
• Change the filename.
7 There is not enough space to
create:_filename_. The system is trying to save a file
but there is not enough disk
space. Remove any unnecessary files to
increase free disk space.
8 There are too many files to
open _filename_. Too many files open. Close some files and or
applications.
9 You do not have permission
to open file _filename_. The file permission is invalid. Rerun the application.
10 Error copying print LUT to
DP2 folder (can’t open
_filename_. Folder doesn’t exist or is read-
only. Modify protection on folder.
11 Error creating DP2 LUT
folder A folder of the same name may
exist. Change the selected folder name.
101 No response from
device:_devicename_. The device is not responding to
the system. Verify that the device is connected
and on-line.
102 Device not
found:_devicename_. The system was trying to access
a device that it could not find. Verify that the device name on one
of the configuration dialog
windows is correct.
103 The following device is
indicating it is not
ready:_devicename_. The device is not ready. Wait several minutes and try the
activity again.
104 The following device is
busy:_devicename_. The device is busy. Wait several minutes and try the
activity again.
105 The following device is not a
TTY port:_devicename_. The port name in the
configuration file does not refer to
a valid serial port. Change the port name in the
configuration file to a valid serial
port.