Siemens 300 - Manual (Page 49)

49
Appendix
Gigaset USB Adapter 300 / multilanguage / A31008-M1066-R101-2x-7619 / appendix.fm / 14.11.2008
Sc
hablone 200
4_12
_27
Installation
cancels under
Windows 2000. If the following error message appears during Gigaset USB
Adapter 300 installation on the Windows 2000 operating sys-
tem: “1608: Unable to create InstallDriver instance” and the
installation is cancelled, this is due to the fact that the Micro-
soft Network Client component is missing.
To install the Microsoft Network Client:
ì
Select Start – Settings – Control Panel – Network and
Dial-up Connections.
ì
Right-click LAN Connection and select Properties.
ì
Then click the following: Install – Client – Add – Client for
Microsoft Networks – OK.
The Microsoft Network Client component is now installed.
ì
Restart your PC to apply the change.
ì
Install the software, see the section entitled "Installing the
Gigaset USB Adapter 300" on page 11.
The data transfer
rate seems too low.
ì
If possible, position your PC with the Gigaset USB Adapter
300 closer to the access point or remove any obstacles in
the line of sight.
ì
Re-align the antennae on the access point.
ì
Change the transfer rate from AUTO to a fixed value if nec-
essary.
ì
You have to change the transmission mode of the Gigaset
USB Adapter 300 to 802.11g.
ì
Try another channel. Make sure that you change the chan-
nel setting on the access point first.
The Gigaset USB
Adapter 300 does
not work properly. You have checked all of the causes specified above and still no
communication is possible.
ì
Uninstall the software and install it again as described in
the sections entitled "Uninstalling the Gigaset USB Adapter
300" on page 44 and "Installing the Gigaset USB Adapter
300" on page 11.
Problem Causes and remedies