beautypg.com

Reach of wireless connections over wlan – Siemens 300 User Manual

Page 10

background image

10

The Gigaset USB Adapter 300

Gigaset USB Adapter 300 / multilanguage / A31008-M1066-R101-2x-7619 / introduction.fm / 14.11.2008

Sc

hablone 200

4_12

_27

WPS

Wi-Fi Protected Setup (

WPS

) makes it easier to establish a wireless network. A wireless

network has a name (SSID) and requires encryption of data traffic against the risk of
eavesdropping. The access point requires authentication with an SSID and key to allow
a WLAN adapter to access the services.
Devices with WPS automatically create a SSID and a WPA encryption key (Pre-Shared
Key) and synchronise with each other.
WPS provides two possibilities:

u

Push Button Configuration (PBC)
This is the registration mode Without PIN (Apply) on your Gigaset USB Adapter 300.
A WPS button is provided on the access point (e g. Gigaset SE 366) and a Registration
button on Gigaset devices. After pressing this button, the device is ready for regis-
tration for two minutes. The first time you press the button, the device automatically
creates an SSID and a Pre-Shared Key. If a client (WLAN adapter) activates its WPS
function within these two minutes, the security data is interchanged and a connec-
tion is established. It is ensured that only one client can synchronise within the two
minutes.

u

Personal Identification Number (PIN)
This is the registration mode Enter partner device PIN or Send own PIN respec-
tively on your Gigaset USB Adapter 300. A PIN is generated on one device (access
point or client) and has to be entered on the other device. The security data is then
synchronised.

When you use an access point without WPS in your network, you can configure the secu-
rity settings (SSID and key) for the Gigaset USB Adapter 300 manually. You cannot use
WPS for networks with WEP encryption.
The Gigaset USB Adapter 300 supports WPS. For further information, see chapter
"Configuration with WPS" on page 21.

Reach of wireless connections over WLAN

Outdoor reach is up to 300 m. In buildings, the reach is up to 50 m. Depending on the
environmental conditions, features of the rooms and buildings, the reach may be con-
siderably less. You can increase the reach of your wireless network by changing the
alignment of the antenna, positioning your device at another place or installing a
repeater, e.g. the Gigaset SE365 WLAN, at the point where your current reach expires.