Siemens 300 User Manual

Page 47

Appendix

Gigaset USB Adapter 300 / multilanguage / A31008-M1066-R101-2x-7619 / appendix.fm / 14.11.2008

hablone 200

4_12

_27

The connection is
not set up at all or is
not set up correctly.

If you cannot establish a connection between your PC with the
Gigaset USB Adapter 300 and another wireless network
adapter, this may be due to a number of reasons:
The PC you want to connect to has not been powered up.

Power up the PC.

The transmission speed set does not match that of the partners
in the network.

Check whether you have set a particular transmission
speed. If this is the case, change to "Auto" (infrastructure
mode).

You are working in an ad-hoc network and a different radio
channel is being used.

Select the correct radio channel.

The wrong mode has been set (infrastructure or ad-hoc mode).

Select the correct mode.

The SSIDs of the devices that are to communicate with each
other do not match.

Make sure that all connection partners with network adapt-
ers use the same SSID for wireless operation.

Different encryption methods are used.

Select the same encryption method on all devices.

Changes in the configuration are not applied by your PC

Reboot your PC.

The IP address or the subnet mask is configured incorrectly.

Make sure that the IP address and the subnet mask are con-
figured correctly on the IP Settings tab.
As a rule, it is necessary to assign static IP addresses when
operating a network in ad-hoc mode.

Problem

Causes and remedies