Sanyo CHDZ09053 - Manual (Page 89)

3-35
Control of W-3WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
3. Timer Remote Controller
Deleting the Program Timer
To delete the program timer setting, follow the steps below.
1. Press to enter the program confi rmation mode.
2. Press / to select the day of the program you want to de-
lete.
3. Press / to select a TIMER No. (from 1 to 6).
4. Press to display the program setting mode .
5. Press to delete the program.
NOTE
After deleting, the unit returns to the program confi rmation mode .
If you press during the setting, the unit returns to the program
confi rmation mode.
If there is no operation made for 3 minutes during the setting, the unit re-
turns to the normal mode.
Invalidating Program Timer
If you want to adjourn the program operation for more than 1 week, you can
invalidate all the timer settings.
Once the timer settings are invalidated, the program will not be operated until the invalidation is cancelled.
<>
Press and hold for more than 2 seconds.
is displayed and the programs will be invalidated from the next one.
<>
Press and hold for more than 2 seconds.
disappears and the programs will be validated from the next one.
If Power Failure Occurred
If the power recovers in a short time period, the program after the recovered time will be valid.
If the power recovered more than 1 hour after the failure, the present time information will be lost. In this case, the program will
not be operated.
4 3 5 1 2