Sanyo CHDZ09053 - Manual (Page 47)

2-37
Design of W-3WAY ECO-i SYSTEM Unit Specifi cations
1
2
3
4
5
6
7
8
4. Installation Instructions
Fig. 4-16
Remove the 2 screws
(8 screws total)
Remove the 2 transport brackets from
the front and rear (4 brackets total)
Remove 2 screws
Tubing cover
Bottom
Front
Remove 11 panel
screws from front
panel
Use cutting pliers or similar
tool to cut cover out
Fig. 4-15
Indentation
(4 locations)
Slit hole
Fig. 4-14
4-11. Routing the Tubing
The tubing can be routed out either from the front or from the bottom. (Fig. 4-15)
The connecting valve is contained inside the unit. Therefore, remove the front panel. (Fig. 4-15)
(1) If the tubing is routed out from the front, use cutting pliers or a similar tool to cut out the tubing outlet slit (part indicated by
) from the tubing cover. (Figs. 4-15 and 4-16)
4-10. Remove the Brackets Used for Transport
After installing the unit, remove the 2 transport brack-
ets from the front and rear (4 brackets total). (Fig. 4-14)
(2) If the tubing is routed out from the bottom, remove the slit
part ( ).
Use a drill bit approximately 13/64" dia. to create holes at
the 4 slit hole indentations (openings).
Punch out the slit part ( ).
Be careful not to damage the base plate.