Sony BRC-Z700 - Manual (Page 53)

In
s
ta
llat
ion
a
nd
Conne
c
tio
ns
Installation
53
Installation and Connections
Installation
Attaching an Interface Board
Attach an Interface Board (not supplied) to the card slot
on the rear of the camera.
1
Loosen the two screws to remove the card slot
cover.
2
Insert an optional Interface Board into the card slot.
Align both ends of the Interface Board with the
sliders inside the slot, then insert the board securely
as far as it will go.
3
Tighten the two screws on the Interface Board.
To remove the Interface Board
Loosen the two screws on the Interface Board and pull
the board out straight and slowly.
Installing the Camera
To install the camera on a desk
Place the camera on a flat surface.
Interface board
(not supplied)