Sony BRC-Z700 - Manual (Page 46)

O
p
e
rat
ion Using t
he RM-B
R30
0
Remot
e
Cont
rol Unit
Turning on the Power
46
Before operating, check that the camera, the RM-BR300
Remote Control Unit and peripheral devices are
properly installed and connected.
For details, see “Installation” (page 53) and
“Connections” (page 61).
Turning on the Power
1
Connect the camera to an AC outlet using the
supplied AC power adaptor and power cord.
The power is turned on and the POWER lamp
lights.
The camera will automatically pan and tilt and be
reset to the position stored in POSITION 1 (Pan/tilt
reset action).
2
Press the ON/OFF switch on the RM-BR300
Remote Control Unit to turn it on.
The CAMERA button representing the camera
whose power was turned off last lights. (The
CAMERA 1 button lights by default.)
3
Turn on the peripheral devices.
Note
Be sure to turn on the power of the camera before the
power of the Remote Control Unit. Otherwise, the
Remote Control Unit cannot recognize the connected
camera.
To turn on/off the camera using the RM-
BR300 Remote Control Unit
As long as the camera is connected to an AC outlet, you
can turn the camera on or off with the POWER button on
the Remote Control Unit.
While holding down the POWER button, press the
CAMERA button corresponding to the camera whose
power you want to turn on/off.
When you turn the power off using the Remote Control
Unit, the POWER lamp turns off and the STANDBY
lamp lights on the camera.
To illuminate the panel of the Remote
Control Unit
Press the PANEL LIGHT button. All the POSITION
buttons and CAMERA buttons light.
To turn off the illumination, press the PANEL LIGHT
button again.
Operating Multiple Cameras
Before operating, you must assign the camera addresses
to the connected cameras as follows. Then you can
switch the camera to be controlled simply by pressing
the corresponding CAMERA button.
To assign camera addresses
automatically
1
Make sure that the camera address selector on the
bottom of each camera is set to “0.”
For setting the camera address selector, see
page 19.
2
Turn on the power of all the connected cameras and
the RM-BR300 Remote Control Unit.
Operation Using the RM-BR300
Remote Control Unit
1
1
9
LOCK
MODE
VALUE
RESET
MENU
PRESET
SHIFT
L/R DIRECTION
PANEL
LIGHT BLACK LIGHT PAN-TILT RESET ONE PUSH AWB
POWER AUTO MANUAL
AUTO
ONE PUSH AF
2 3 4 5 6 7
2
10
STD REV
3
11
4
POSITION
CAMERA
12
5
13
6
14
7
15
8
16
R – +
BRIGHT
B – +
FOCUS
NEAR FAR
1 2 PANEL LIGHT
POWER CAMERA
RESET
STANDBY lights.
PANEL
LIGHT