Setting the autonegotiation mode – Sun Microsystems GigaSwift Ethernet Adapter User Manual

Page 71

Chapter 4

Configuring Driver Parameters

●

To list all the parameters supported by the

driver, type

See

through

for parameter descriptions.

Setting the Autonegotiation Mode

By default, autonegotiation is set to

. This means that the adapter communicates

with its link partner to determine a compatible network speed, duplex mode, and
flow control capability.

# ndd /dev/ce

name to get/set ? ?

? (read only)

instance (read and write)

adv_autoneg_cap (read and write)

adv_1000fdx_cap (read and write)

adv_1000hdx_cap (read and write)

adv_100T4_cap (read and write)

adv_100fdx_cap (read and write)

adv_100hdx_cap (read and write)

adv_10fdx_cap (read and write)

adv_10hdx_cap (read and write)

adv_asmpause_cap (read and write)

adv_pause_cap (read and write)

master_cfg_enable (read and write)

master_cfg_value (read and write)

use_int_xcvr (read and write)

enable_ipg0 (read and write)

ipg0 (read and write)

ipg1 (read and write)

ipg2 (read and write)

rx_intr_pkts (read and write)

rx_intr_time (read and write)

red_dv4to6k (read and write)

red_dv6to8k (read and write)

red_dv8to10k (read and write)

red_dv10to12k (read and write)

tx_dma_weight (read and write)

rx_dma_weight (read and write)

infinite_burst (read and write)

disable_64bit (read and write)

accept_jumbo (read and write)

name to get/set ?