Sun Microsystems GigaSwift Ethernet Adapter - Manual (Page 33)

Chapter 2 Installing the Adapter 11
4. View the .properties file for a list of device properties.
The . properties command displays the specific information about the installed
adapter. If you are using the Sun GigaSwift Ethernet MMF adapter, your output will
be similar to the following.
ok cd /pci@8,700000/network@2
ok .properties
assigned-addresses 82001010 00000000 00200000 00000000 00200000
82001030 00000000 11000000 00000000 00100000
d-fru-len 00 00 00 00
d-fru-off 00 00 e8 00
d-fru-dev eeprom
s-fru-len 00 00 08 00
s-fru-off 00 00 e0 00
s-fru-dev eeprom
compatible 70 63 69 31 30 30 62 2c 33 35 2e 33 30 00 70 63
reg 00001000 00000000 00000000 00000000 00000000
02001010 00000000 00000000 00000000 00200000
02001030 00000000 00000000 00000000 00100000
address-bits 00 00 00 30
max-frame-size 00 00 40 00
network-interface-type ethernet
device_type network
name network
local-mac-address 00 03 ba 4e 7f 0b
version Sun PCI Gigaswift 1000Base-X FCode 2.12.4 04/03/25
phy-type pcs
board-model 501-6762
model SUNW,pci-ce
fcode-rom-offset 00000000
66mhz-capable
fast-back-to-back
devsel-speed 00000002
class-code 00020000
interrupts 00000001
00000002
00000003
00000004
latency-timer 00000040
cache-line-size 00000010
max-latency 00000040
min-grant 00000040
revision-id 00000030
device-id 00000035
vendor-id 0000100b