Sun Microsystems TIMBERWOLF 9740 - Manual (Page 55)

95693 Revision P 3-23
Operating in Manual Mode
4. Insert the cartridge into the shuttle and push the cartridge into the back of
the drive until it is firmly seated.
5. Push the shuttle completely back, pause for about two seconds, then
release the shuttle.
CAUTION:
If the cartridge has been ejected from the drive, you must remove it from
the shuttle before you can reload it into the drive. Otherwise, the shuttle
will become jammed by simultaneously holding on to the cartridge and
lowering the handle.
If this happens, release the cartridge from the shuttle latch under the
right side of the cartridge. Then push the cartridge into the drive and
lower the handle.
Dismounting a Cartridge from a DLT Drive
To dismount a cartridge from a DLT drive:
1. Make sure that the Operate Handle indicator is on.
2. Push the shuttle completely back, pause for about two seconds, then
release the shuttle.
Note: If the cartridge does not come out of the drive, remount the
cartridge by releasing it from the shuttle latch under the right side of
the cartridge. Then push the cartridge into the drive and lower the
handle. If this fails, the tape leader might be dislodged and require
rethreading.
3. Remove the cartridge from the drive.
4. Store the cartridge outside the LSM.