Sun Microsystems TIMBERWOLF 9740 - Manual (Page 30)

Setting the SCSI Address
2-4 Revision P 95693
Figure 2-3. Operator Panel Function Keys, Indicators, and Displays (C62014)
C62014
IPL
SERVICE REQ
(OPERATOR PANEL DISPLAY) PROCESSOR ACTIVE
INTERFACE ACTIVE
MENU
RESET EXECUTE
Initiates the download from the diskette. The IPL sequence consists of
PROM tests, boot tests, and machine initialization.
DESIGNED FOR CSE USE ONLY! NOT an operator activity. Initiates
a dump.
Displays machine status and menu information. It also prompts the operator
to perform certain functions.
When the display shows "ONLINE - PRESS EXE TO UNLK CAP," and you want
to unlock the CAP so that you can place a cartridge into it, press EXECUTE
to send a message to the robot to unlock the CAP.
When the display shows "ONLINE CAP UNLK DISABLD," the CAP is locked by
the host. To open the CAP for entering cartridges, enter the "open"
command from the system console. The display will change to "ONLINE
PRESS EXECUTE TO UNLOCK CAP." Once you have pressed EXECUTE, the
display will change to "ONLINE CAP UNLK PENDING." The robot will then
unlock the CAP and the display will show "ONLINE CAP UNLOCKED."
When the display shows "ONLINE CAP UNLOCKED," and you want it locked,
open and close the CAP. The display will show "ONLINE CAP LOCKED."
IPL
RESET
OPERATOR
PANEL
DISPLAY
Lights when the LSM requires service. The display indicates "INOP" and
the fault symptom code. SERVICE
REQ
Solid light until the functional code is active, then flashes on and off every
second while the controller card is active. PROCESSOR
ACTIVE
Flashes whenever I/O is performed across a host interface or CSE
port. INTERFACE
ACTIVE
Used to set SCSI address and cleaning cartridge usage. MENU
Used to unlock the CAP. When the display shows "ONLINE CAP LOCKED,"
press EXECUTE to send a message to the robot to unlock the CAP. Also
used to set SCSI address and cleaning cartridge usage.
EXECUTE