Sun Microsystems TIMBERWOLF 9740 - Manual (Page 13)

95693 Revision P xi
Preface
This guide describes how to operate the TimberWolf 9740 Library Storage
Module (LSM). Most of the information in this guide pertains to the hardware.
Note: Refer to the appropriate publications for specific information about the
controller transport units, tape drives, software commands, and console
messages.
This guide is intended primarily for data center operators who operate the LSM. System
programmers and computer system administrators might also find the information in this
guide useful.
■
Organization
This guide has the following organization:
Chapter 1 “General Information” describes the LSM hardware.
Chapter 2 “Controls and Indicators” shows the locations of the power switch and
operator panel, and describes their functions. This chapter also shows
how to set the SCSI address and maximum usage count for the cleaning
cartridge.
Chapter 3 “Operating the LSM” contains operating procedures. The procedures
include how to power-on and power-off the LSM, perform automated
operations (enter and eject cartridges through the cartridge access
port), cleaning the tape drives, and perform manual operations (mount
and dismount cartridges).
Chapter 4 “Drives” contains an overview about the different types of controller
transport units and tape drives that attach to the LSM.
Chapter 5 “Service” describes how to contact Customer Support for assistance if
the LSM has a problem.
Appendix A “Cartridge Tape Information” describes how to prepare, inspect, store,
clean, and repair cartridges. It also lists cartridge specifications.
Glossary The Glossary defines new or special terms and abbreviations used in
this publication.
Index The Index assists in locating information in this publication.