Sun Microsystems TIMBERWOLF 9740 - Manual (Page 32)

Setting the SCSI Address
2-6 Revision P 95693
Figure 2-5. Setting the SCSI Address (C62016)
Test Screens
Next Sequence
of Tests Begin
Execute BT0.X
Download BT0.X
Press Execute to
Enter 0 as ID
Press Execute to
Enter 7 as ID
EXECUTE
PRESSED
IPL
PRESSED
EXECUTE
PRESSED
EXECUTE
PRESSED
EXECUTE
PRESSED
MENU
PRESSED
MENU
PRESSED
MENU
PRESSED
MENU
PRESSED
C62016
Exit to IPL
Press Menu
Until This
Screen
Appears
Press Menu
Until This
Screen
Appears
Press Menu
Until This
Screen
Appears
6X
Press Execute to
Store Cfg in NVR
EXECUTE
PRESSED MENU
PRESSED
When more than one
drive is installed, pressing
execute returns you to the
Off/On Bus menu option
until all drives have
been assigned an ID.
14X
Press Execute if
Drv X Off Bus
Press Execute if
Drv X On Bus
Press Execute if
Drv X is ID 0
Press Execute if
Drv X is ID 15
EXECUTE
PRESSED
EXECUTE
PRESSED
EXECUTE
PRESSED
EXECUTE
PRESSED
EXECUTE
PRESSED
MENU
PRESSED
MENU
PRESSED
MENU
PRESSED
MENU
PRESSED
MENU
PRESSED
Drv X: XXX Bus
SCSI ID = XX
SCSI Host
SCSI ID = X
MENU
PRESSED
MENU
PRESSED
Off/On Bus options for drives 1-9 only appear if those
drives are installed and configured and after the
preceding drive has been assigned an ID.
After pressing the execute softkey, there will be a
momentary delay before this screen appears.
Q
Q
Q
Pressing menu accesses screens showing off/on bus
and SCSI ID information for each drive installed and
SCSI host options are ID 0 through 7 for the PRS card
or 0 through 15 for the PRW card.