Sun Microsystems TIMBERWOLF 9740 - Manual (Page 29)

95693 Revision P 2-3
Operator Panel
■
Operator Panel
The operator panel is mounted to the right front door of the LSM. The panel
contains function keys (also referred to as softkeys) and indicators, plus a two-
line display. The operator panel displays LSM status, configuration, test
sequences, and error information.
Figure 2-3 on page 2-4 shows the panel and describes each item.
Use the operator panel to:
• Resolve machine problems
If an error occurs, a fault symptom code (FSC) is displayed. Forward this
code to your service representative to help resolve the problem. Write down
the FSC as soon as it appears to retain an accurate history of what
happened.
The display also instructs you to close the door or cartridge access port.
• Set the SCSI address.
See Figure 2-4 on page 2-5 and Figure 2-5 on page 2-6 for this procedure.
• Set the maximum usage count of the cleaning cartridges.
See Figure 3-2 on page 3-6 for this procedure.
■
Setting the SCSI Address
You set the SCSI address from the operator panel. See Figure 2-4 on page 2-5 and
Figure 2-5 on page 2-6 for the menu block diagrams that describe how to set the SCSI
address to 0 through 7 if you have the PRS card, or 0 through 15 if you have the PRW
card.
CAUTION:
Initialization errors: During this procedure, the panel displays Press
Execute to Enter Lib Size
. This is not normally an operator
function. Altering the library size can cause initialization errors if the
size is set incorrectly to full size and the library only holds 326
cartridges instead of 494 cartridges. Press the MENU button and
continue through the choices as shown in the block diagram.