Siemens PC 670 - Manual (Page 98)

Configuring the Computing Unit in BIOS Setup Release 04/02
5-10 Panel PC 670 Computing Unit, Equipment Manual
Submenu ”Boot Options”
The following submenu appears when you select the option “Boot Options” in
the main menu:
PhoenixBIOS Setup Utility
Item Specific Help
QuickBoot Mode:
ESC Exit
Select Item
Select Menu
+ / –
Select
Change Values
Sub-Menu
F9
F10 Setup Defaults
Save and Exit
SETUP prompt: [Enabled]
POST Errors: [Enabled]
Floppy check:
Allows the system to
skip certain tests
while booting. This
will decrease the
time needed to boot
the system.
Enter
Help F1
Main
Boot Options
[ Enabled ]
Summary screen:
[Disabled]
[Enabled]
Figure 5-5 ”Boot Options” Submenu
Quick Boot
Mode Some hardware tests are skipped when the system starts up, thus
speeding up the boot procedure.
SETUP prompt The message PRESS to enter Setup appears at the bottom of
the screen during the system load phase.
POST Errors The boot process is stopped if an error is detected; you must press F1 to
acknowledge. Enter “Disabled”to avoid the necessity of acknowledging
errors, for example if no keyboard is connected.