Siemens 2010 Tango - Manual (Page 58)

Operating more than one handset
48
kap15.fm5 18.7.99 Gigaset 2010, LAM/engl.: A30852-X1100-B313-1-7619
Operating more than one handset
Registering/de-registering more than one handsets at the base station
You can operate up to six handsets from the Gigaset
2000 Tango family at a Gigaset 2010 Tango base station.
The handset supplied with your telephone is already re-
gistered at the base station with the internal call number
1 and base number 1.
Each additional handset that you purchase must be regis-
tered at the base station. We recommend that when you
are registering other handsets at the base station, to keep
the base number 1 for this base station.
Registering a Gigaset 2000S Tango handset at a base station
Prepare the base station
Register the handset
You can only register handsets from the Gigaset
Tango family. It is not possible to register other
Gigaset handsets.
If you want to operate your handset at more
than one base station (up to four) (➔ page 48),
you must repeat the following procedure at
each base station.
The handset must be turned off (➔ page 14)
?
Press the base station paging key until you hear the logon
tone (after approximately ten seconds).
1
or 2,3,4 The handset is off. Press number of base station.
h Press also this key. The handset is on.
Examples: Registering
● Registering at a base station
Press 1 and h .
Station number
● Registering at a 2nd base station
Press 2 and h .
1
f
N