Siemens 2010 Tango - Manual (Page 29)

Operating modes
19
kap04.fm5 18.7.99 Gigaset 2010, LAM/engl.: A30852-X1100-B313-1-7619
Changing the system code, changing the PIN
To protect your personal settings, Gigaset 2010 Tango has
two code numbers, a four-digit system code and a four-
digit handset PIN (personal identification number). The
factory defaults are as follows:
● System code : "0000"
● Handset PIN : "0000"
You need to know the system code in order to create ba-
sic settings or to lock the telephone for outgoing calls.
The system code can thus be described as the main code
for your Gigaset 2010 Tango telephone.
The PIN primarily protects settings on your handset(s),
but it has no effect on the basic functions of the base sta-
tion. For security reasons, a new system code and a new
PIN should be entered.
If several handsets are operated (➔ page 48), the same
system code is valid for each one.
Changing the system code
Changing the handset PIN
B
# 8 * Start setting procedure.
o
Enter the current system code (factory default "0000").
o
Enter the new four-digit system code. Note carefully the
number entered.
o Enter the new system code again to confirm.
B Store the setting.
B
8 9 Start setting procedure.
o
Enter the current PIN (factory default "0000").
o
Enter the new four-digit PIN. Note carefully the number
entered.
o Enter the new PIN again to confirm.
B Store the setting.
When entering a new system code or PIN you
must not forget the number entered. Other-
wise intervention in the device is necessary. If
this happens, please contact your specialist
dealer.