Siemens 2010 Tango - Manual (Page 41)

Internal consultation calls and transferring calls
31
kap08.fm5 18.7.99 Gigaset 2010, LAM/engl.: A30852-X1100-B313-1-7619
Transferring calls
When more than one handsets are in operation
It is possible to transfer an external call to an internal party
when more than one handset is in operation (➔ page 48).
When a telephone system is in operation
If a telephone system is in operation, you can transfer an
external call to another internal party. Please check the
operating instructions for the telephone system.
I
o
Press the internal key. Enter the number of the handset
to which you want to transfer the call (1 to 6). You will
hear the internal ring tone. The handset is being called.
The external call is held.
either
Wait until the internal party answers and inform him/her
about the external call you are about to transfer.
a Transfer the external call by pressing the on-hook key.
or
a Do not wait until the internal party answers and transfer
the external call directly by pressing the on-hook key.
Instead of pressing a , you can also replace
your handset in the charging unit.
If you have transferred the external call directly
and the internal party does not accept the call
within 30 seconds, an automatic recall is carried
out.
If you have transferred the external call directly
and the internal party is busy, an automatic re-
call is carried out immediately.
If you accept the recall, you will be reconnected
to the external party. A recall is accepted in the
same way as all other calls (➔ page 22).
R Setup a consultation call. You will hear the dial tone. The
external call is held.
o
Enter the desired extension number. The party in ques-
tion is called.
Wait until the party answers and inform him/her about the
external call you are about to transfer.
a Transfer the external call by pressing the on-hook key.