Siemens 2010 Tango - Manual (Page 31)

Operating modes
21
kap04.fm5 18.7.99 Gigaset 2010, LAM/engl.: A30852-X1100-B313-1-7619
Resetting the Gigaset 2000S Tango handset to factory defaults
You can use this procedure to reset the following settings
to factory defaults:
● Ringer volume (➔ page 34)
● Ringer tone (➔ page 34)
● Handset volume (➔ page 35)
● Base station number (➔ page 52)
● Battery warning signal (➔ page 36)
● Range warning signal (➔ page 36)
● Synchronization tone (➔ page 36)
● Automatic call acceptance (➔ page 35)
● Key confirmation tone (➔ page 35)
● Positive confirmation tone (➔ page 36)
● Error beep (➔ page 36)
The following stored data are deleted:
● Redial (➔ page 25)
● Speed dial (➔ page 37)
The stored handset PIN (➔ page 19) is not
deleted.
B
8 Q
Start setting procedure.
o
You are requested to enter the PIN (factory
default "0000") (➔ page 19).
B
Confirming the PIN resets the settings to factory
defaults.