Siemens 2010 Tango - Manual (Page 27)

Operating modes
17
kap04.fm5 18.7.99 Gigaset 2010, LAM/engl.: A30852-X1100-B313-1-7619
Setting the flash time in dual-tone multifrequency signalling (DTMF)
Exchange codes
For through connection to the public telephone network
you must set:
● the exchange code
● the pause length after the exchange code (if a pause
is necessary after entry of the exchange code)
If the telephone system is connected as a subsystem to
a main system, you must set the:
● the exchange code
● the main system exchange code
● the pause length after the exchange code
B
# 1
Start the setting procedure.
o
Enter the four-digit base code (factory default: “0000“)
(➔ page 19).
O
930
B Set a flash time of 80 ms.
or
O
936
B Set a flash time of 100 ms (factory default).
or
O
933
B Set a flash time of 300 ms.
or
O 934 B Set a flash time of 600 ms.
For the pause length to be entered after the ex-
change code, please consult the documentation
about your telephone system.