Southbend 18' & 60: EVS Toolroom Lathes 220v sb1016 User Manual
Page 29
For Machines Mfg. Since 7/09
Model SB1016/SB1036
-27-
P R E P A R A T I O N
14.
Make sure that all bystanders are out of the
way, tools are cleared away, and the chuck
key is removed from the chuck.
15.
Move the spindle ON/OFF lever (Figure
26) down and the chuck will rotate counter-
clockwise (down and toward you, as you face
the front of the lathe).
Figure 25. Oil pump sight glass.
Oil Pump
Sight Glass
Figure 26. Starting the lathe.
16.
Observe the lathe and listen for any
abnormal noises or vibration. The lathe
should run smoothly. If the spindle rotates in
the incorrect direction, refer to Correcting
Phase Polarity
on
Page 16 to solve the
problem.
17.
Push the stop button. The lathe should stop.
18.
Move the spindle ON/OFF lever up to the
OFF position, reset the stop button by
twisting it clockwise until it pops out, then
restart the spindle with the lever.
19.
Push the foot brake. The lathe should come
to a quick stop.
— If the foot brake has no effect on the lathe,
push the stop button, and refer to V-Belts
and Brake & Switch on Page 81 to
make any required adjustments.
20.
Remove the lathe headstock side cover.
The kill switch shown in Figure 27 should
prevent the lathe from starting while this
cover is removed.
21.
Stand away from all the exposed gears on
the side of the headstock, and attempt to
start the lathe.
— If the lathe starts, the safety switch is not
functioning properly and may need to be
replaced before the machine can be safely
operated.
22.
Reinstall the end gear cover, then start the
lathe.
Figure 27. Headstock gear cover kill switch.
Kill Switch
Spindle ON/OFF Lever