Southbend 18' & 60: EVS Toolroom Lathes 220v sb1016 - Manual (Page 25)

For Machines Mfg. Since 7/09 Model SB1016/SB1036
-23-
P R E P A R A T I O N
Assembly
With the exception of the handwheel handles, the
lathe is shipped fully assembled.
To install the handwheel handles, thread the
large handle into the carriage handwheel and the
small handle into the cross slide handwheel, as
shown in Figure 14.
Figure 14. Handwheel handles installed.
Handwheel Handles
In addition to the gearboxes, we also recommend
that you lubricate all other points on the
machine at this time. This can be accomplished
by following the maintenance schedule on Page
64.
Note: If your lathe was shipped with oil in the
gearboxes, do not change that oil until after the
break-in period.
Lubricating Lathe
GEARBOXES MUST
BE FILLED WITH OIL!
NO OIL SHIPPED WITH
MACHINE!
Refer to the Lubrication
Section in this Manual
for Recommended
Oil Type.
Adding Cutting Fluid
Add the cutting fluid of your choice now. For
detailed instructions on where the cutting fluid
tank is located and how to add fluid, refer to
Cutting Fluid System on Page 73.
The headstock oil pump tank, gearbox, and apron
must have the proper amount and type of oil in
them before the lathe can be operated for the
first time.
Running the lathe without the required oil will
void the warranty. Refer to the Lubrication
section, beginning on Page 66, for details on how
to check and add oil.