Symbol Technologies P470 - Manual (Page 71)

5-1
Chapter 5
Parameter Menus
Introduction
This chapter has the optional parameter bar codes necessary to program the RF scanner.
Operational Parameters
The RF scanner is shipped with the settings shown in Table 5-1 . These default values are
stored in non-volatile memory and are preserved even when the scanner is powered down.
You can change these default values by scanning the appropriate bar codes included in this
manual. These new values replace the standard default values in memory. The default
parameter values can be recalled by scanning the bar code in the section
Set Default
Parameter on page 5-7.
The scanner automatically detects which cable it is attached to, either an RS-232 or a
Synapse cable. If it is attached to an RS-232 cable and has either an ICL, Nixdorf, or Fujitsu
host interface, then scan the appropriate bar code from page
5-10 after power up. Any other
RS-232 host interface works with the default setting.
If it is attached to a Synapse cable, plug everything together as described on page 2-3 and
then follow the directions that come with the Synapse cable for setting up the host interface.