Sharp JW-21MN - Manual (Page 92)

14-2
(1) Load to the personal computer
Load the contents of the floppy diskette into the memory of the personal computer.
Select "FD TRANS."
Select "Load."
Select a file name.
Press the "Enter" key.
Start loading into the personal computer.
Select "PC TRANS."
Select "Write."
Select "DL M. stn. PARAM." or "DL S. stn.
PARAM."
When the connected JW-21MN is a master station, select "DL M. stn.
PARAM." When the connected JW-21MN is a slave station, select "DL S. stn.
PARAM."
After selecting "PC stop," press the "Operation
stops" key.
(2) Stop operation of the JW-21MN
After stopping operation, load the memory contents of the personal computer into the JW-21MN.
JW-21MN
JW-50SP
(3) Load to the JW-21MN
After stopping operation, load the memory contents of the personal computer into the JW-
21MN.
(4) Start operation of the JW-21MN
After loading the parameters from the personal computer, start operation of the JW-21MN.
After selecting "Parameter writing," press
the "Enter" key.
Start loading into the JW-21MN.
After selecting "Start: write EEPROM" or
"Execution start," press the "Enter" key.
Start operation of the JW-21MN