Sharp JW-21MN - Manual (Page 64)

11-11
1000
Time limited contact
000000
000377
000400
000677
I / O relay
0000
0377
b0000
File
address (8)
Byte
address
Relay link area setting range
015000
015777
0400
Auxiliary relay
0677
000700
000777 0700
Latched relay
0777
001000
001577
General
purpose
relay 1577
001600
001777
ponit of TMR/CNT
002000
004777
Register
004000
Current value of
TMR/CNT/MD
b1777 003777
09000
09777
005777
Register
005000 19000
19777
006777
Register
006000 29000
29777
007777
Register
007000 39000
39777
010777
Register
010000 49000
49777
011777
011000
Register
59000
59777
Register
99000
99777
Register link area setting range
Flag area setting range
1000
000000 0000
File
address (8)
Byte
address
Relay link area
011000
015777
001000 Module No. 0
001477
001500
003777
004777
Module No. 0
004000 09000
09777
005777
005000 19000
19777
006777
006000 29000
29777
007777
007000 39000
39777
010777
010000 49000
49777
59000
99777
Flag area setting range
1100 Module No. 1
1200 Module No. 2
1300 Module No. 3
1400 Module No. 4
1500
Module No. 1
Module No. 2
Module No. 3
Module No. 4
Register link area
[3] Setting range of relay link area, register link area, and flag area
For setting the top address of the master stations relay link, register link, and flag area, use the file
address
(8)
allocated throughout the memory area and set the number of sending bytes of the relay link
and register link area within the setting range shown below. Flag areas are allocated by 24 bytes from
each top address.
When a slave station is a JW-21MN and it is set to data link (the standard function), set the top address
and the number of sending bytes of the slave station's relay link and register link area within the setting
range shown below.
When a slave station is a JW-21MN and it is set to data link (the save memory function), the relay link
and register link area of the slave station are determined by the setting value of the JW-21MN module
No. switch (page 11-2) as shown below.
- When master and slave stations are
JW-21MN and set to data link (the
standard function) :
- When slave stations are JW-21MN
and set to data link (the save memory
function) :
(1) When master station PC is JW20/JW20H