Sharp JW-21MN - Manual (Page 108)

16-13
16-4 Special functions unique to the JW-21MN
The functions below are not covered by the ME-NET specifications. They can only be used with PCs
which are equipped with a JW-21MN, ME-NET module JW-20MN or ZW-20CM2.
(1) Remote programming and remote monitor
This paragraph describes the operation procedure of any other station's PC which is connected on
the ME-NET. The following support tools are available:
Hand-held programmer ..................... JW-14PG/13PG/12PG
Multipurpose programmer ................. JW-50PG
Ladder software ................................. JW-92SP, JW-50SP
Ladder logic programming software .. JW-100SP
NOTE
Support tool
JW30H
Opposite module
Support tool
With 30Hn mark
With 30Hn mark
With 30H mark
ZW-20CM2 with JW mark
With 30Hn mark
With 30H mark
ZW-20CM2 with JW mark
With 30Hn mark
With 30H mark
ZW-20CM2 without JW mark
JW-12PG,
JW-92SP Ver4.0A
With 30H mark
Opposite module
JW-21MN JW-20MN
without mark
JW-21MN JW-20MN
without mark
JW-21MN JW-20MN
without mark
Support tool
connection module
Support tool
connection module
All functions are available
Seen as a JW-31CUH/32CUH/33CUH
standard JW30 model)
Seen as a JW-22CU/50CUH
Seen as a JW-50CU
- When you use the remote programming or remote monitor function after installing
the ZW-20CM2, you cannot use the JW50H/70H/100H extension functions that are
included on the JW50/70/100 models.
JW-14PG JW-13PG B ,
JW-92SP (Ver5.5 or
better
JW-100SP
JW-13PG, JW-13PG A ,
JW-92SP Ver5.0 to
5.3A
- Remote programming operations when different software versions are
combined. (When a JW30H is used.)