Sharp JW-21MN - Manual (Page 66)

11-13
[4] Setting procedure
Set parameters of the master station following the procedure below.
[ ] : See page in chapter 11
to are equivalent to number of page 11-5, and 11-6.
Start slave station PC operation
Turn ON the power of master station PC [ 14 ]
Connect support tools [ 14 ]
Stop PC operation [ 14 ]
[ 14 ]
Stop operation of data link (007777
(8)
=00
(H)
) [ 14 ]
Set top address of the relay link area on the master station [ 15 ]
Set data link function (004002
(8)
=01
(H)
) [ 15 ]
Set number of connecting stations [ 15 ]
[ 15 ]
Set top address of register link area on master stations [ 16 ]
Set top address of register link area on slave station 01 to 77
(8)
(at standard function)
/number of off set bytes (save memory function)
[ 17 ]
Set number of sending bytes of the master station relay link [ 17 ]
Set number of sending bytes of the slave station 01 to 77
(8)
relay link [ 18 ]
Set number of sending bytes of the master station register link [ 18 ]
[ 18 ] Set number of sending bytes of the slave station 01 to 77
(8)
register link
Whether the station number information should be output or not
Set connection status of slave stations [ 19 ]
[ 19 ]
Set top address of flag area [ 20 ]
Writing to EEPROM, start operation (007777
(8)
=81
(H)
) [ 21 ]
PC operation [ 21 ]
End
Set top address of relay link area on slave station 01 to 77
(8)
(at standard function)
/number of offset bytes (at save memory function)
V2