Sharp OZ-800 - Manual (Page 15)

Getting Started 13
Setting up the unit
After battery installation, the unit takes you through various steps needed to setup
the unit before use. It is recommended to complete the entire setup procedures
described below.
Adjusting the touch panel
The Calibration screen appears.
1.
Tap the center of the target with the stylus.
The target moves to another position.
2.
Repeat step 1 until you tap the target at the bottom right of the screen.
3.
Tap “Q” followed by “P” on the tablet keyboard according to the instructions
displayed on the screen.
Adjusting the LCD contrast
After adjusting the touch panel, the Contrast screen appears.
1.
Press or tap icons on the screen to adjust the LCD contrast.
2.
Tap “NEXT”.
Setting the CLOCK
After setting the LCD contrast, the Time/Date Setting screen appears.
City:
1.
Highlight “City” by pressing and press .
2. Select the desired city by pressing and press .
00.Introduction.book Page 13 Friday, March 15, 2002 3:17 PM