Sharp DV-RW550U - Manual (Page 96)

96
VCR functions
Recording and One-touch Timer Recording (cont’d)
This feature allows you to set the
recording length simply by pressing
REC/OTR on the remote control
or the front panel of the unit.
1
During normal recording,
press REC/OTR to begin one-
touch timer recording.
You can select a fixed recording
time by pressing REC/OTR
repeatedly.
When one-touch timer recording
is finished, the unit will turn off
automatically.
To change the recording length
during the one-touch timer
recording, press REC/OTR
repeatedly until the desired length
appear.
To cancel the one-touch timer
recording within the specified
time, press STOP C.
press first. VCR
1
One-touch Timer Recording
(0:30) (1:00)
(Normal recording)
(7:30) (8:00)
Search
An index mark will be assigned at
the beginning of each recording
you make. You may skip to a spe-
cific marked point by following the
steps below.
1
Press SEARCH so that the
index search menu appears.
2
Enter the number of record-
ings you wish to skip using
the Number buttons within
30 seconds.
3
Press h / g to start index
search.
If you want to go in the forward
direction, press g.
If you want to go in the reverse
direction, press h.
After index search, the VCR will
play the videotape automatically.
Pro. 1 Pro.2 Pro.3 Pro.4 Pro.5
02 0 1 0 1 02 03
Beginning
of tape End
of tape
CURRENT PROGRAM
INDEX MARK
INDEX SEARCH
03
press first. VCR
Index search
VCR/DVD RECORDER
COMBINATION
3
2
Note
• Every time a videotape is
recorded, an index mark is
written on the videotape.
• You can make the index mark
up to 20.
Note
• The remaining recording time
will appear on the display panel
during an one-touch timer
recording. Press DISPLAY to
see it on the TV screen.
• You cannot pause a one-
touch timer recording.
• If OTR is finished in VCR during
playback or REC mode in DVD, the
VCR will be in STOP mode and
the DVD keeps the current mode.
• Unlike a timer recording, you can
perform the following operations
during a one-touch timer recording.
- Turning the power off.
- Using REC/OTR or STOP C.
• When OTR is finished and the power is
turned off, the unit will switch to the
standby mode automatically if a Timer
Recording has been programmed. Press
T-SET to cancel the standby mode for
using the unit continueously.
1
E9656UD_EN_2.qx4 05.7.15 11:59 AM Page 96