Before you start, Functional overview (cont’d), Using a remote control – Sharp DV-RW550U User Manual
Page 10: Installing batteries in the remote control, The vcr/dvd recorder switching
Functional overview (cont’d)
Before you start
Using a remote control
Keep in mind the following when using the remote
control:
• Make sure that there is no obstacle between the
remote control and the remote sensor of the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is on the remote sen-
sor of the unit.
• Remote control for different devices can interfere
with each other. Avoid using remote control for
other equipment located close to the unit.
• Replace the batteries when you notice a fall-off of
the operating range of the remote control.
• The maximum operable range as follows;
Beeline:
approximately 23 feet
(7m)
Either side of center: approximately
16 feet
(5m) within 30 degrees
Above:
approximately
16 feet
(5m) within
15 degrees
Below:
approximately
10 feet
(3m) within 30 degrees
Installing batteries in the remote control
Install two “AA” size batteries (supplied), matching
their polarity to those indicated inside battery com-
partment of the remote control.
1
10
2
3
Because this product is a combination of a VCR and a DVD recorder, you must select first which com-
ponent you wish to operate with OUTPUT SELECT.
VCR/DVD RECORDER
COMBINATION
POWER
STOP/EJECT
REW F.FWD
REC/OTR
PLAY
DUBBING
CHANNEL
VCR
DVD
OUTPUT SELECT
OPEN/CLOSE
STOP
PLAY
REC/OTR
OUTPUT SELECT button
DVD
indicator
VCR
indicator
DVD
button
VCR
button
VCR
DVD
OUTPUT SELECT
Press
VCR on the remote control.
(Verify that the VCR indicator is lit.)
VCR MODE
Press DVD on the remote control.
(Verify that the DVD indicator is lit.)
DVD MODE
The VCR/DVD recorder Switching
Note
Incorrect use of batteries can result in hazards
such as leakage and bursting. Please follow the
instruction below.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
Although they may look similar, different batter-
ies may have different voltages.
• Make sure that the plus and minus ends of each
battery match the indications in the battery
compartment.
• Remove batteries from equipment that is not
going to be used for a month or more.
• When disposing of used batteries, please comply
with governmental regulations or public rules for
environmental protection that apply in your
country or area.
• Do not recharge, short-circuit, heat, burn or dis-
assemble batteries.
Note
• Pressing only OUTPUT SELECT on the front
panel DOES NOT switch the mode of the
remote control. You MUST select the correct
mode on the remote control.
• Pressing REC/OTR (DVD) or REC/OTR (VCR)
on the remote control switches immediately it’s
respective mode so that you can start recording
directly on the appropriate media.
E9656UD_EN_1.qx4 05.7.15 11:55 AM Page 10