Sharp DV-RW550U - Manual (Page 36)

36
Recording
Timer Recording (cont’d)
2
5
4
9
Select a recording speed using
Cursor K / L.
Refer to “Recording speed” on page 26.
If you choose Auto, the unit automati-
cally selects the best recording speed to
make the best quality picture according
to the remaining disc space.
• This function works only on the
Program 1 in the DVD recording.
• The recording may be cut short,
when the available recording space
of the disc is too limited.
10
Press ENTER when all informa-
tion required is entered.
Your program setting will be stored.
• To set another program, repeat STEPs 4 to
10.
• To exit, press TIMER PROG. or
SETUP.
• When programs are overlapped,
“Overlap” and the overlapped program
number will appear on the display.
11
Press T-SET to turn off.
The unit will be set in the timer standby
mode.
indicator will appear on the
front display.
• Also the DVD or VCR indicates in the
display window which you set.
• After this step, the available functions for
the other component will be limited to a
playback and basic recording.You can not
use SETUP or change output mode under
such conditions.
Timer Programming
2. ---
1. JAN/01 12:57AM 1:57AM 8 DVD SP
Date Start End CH Speed
DVD VCR
DVD
VCR
1
Press T-SET so that indicator
disappears from the front display.
2
Press TIMER PROG.
Timer Programming list will appear.
3
Check the information on the
list you will need.
4
To clear the timer programming,
select the program using Cursor
K
/ L.Then, press CLEAR/C.RESET.
To correct the timer program-
ming, select the program using
Cursor K / L. Then, press
ENTER. Next, correct the timer
programming by using
Cursor K / L / { / B.
Finally, press ENTER again.
5
Press TIMER PROG. to exit.
6
Press T-SET to return to the
timer standby mode.
Timer Programming
2. ---
1. JAN/01 12:57AM 1:57AM 8 DVD SP
Date Start End CH Speed
DVD VCR
DVD
VCR
Canceling, or correcting the timer programming information
during the timer standby mode
Press STOP C to stop the disc recording or STOP/EJECT C/A
to stop the videotape recording on the front panel of the main
unit. STOP C on the remote control is not effective.
To stop the Timer Recording in progress
11
10
9
6
1
Note
• To confirm the timer pro-
gramming, press POWER
first and then TIME PROG.
when the unit is in timer
standby mode. Or, press
TIME PROG. while using
the side of the unit that is
free from Timer Recording
(either DVD or VCR).You
cannot select any programs
for correction or add new
programs while the unit is in
timer standby mode.
• When all the Timer Recording
is completed, the indicator
flashes.To play or eject the
recorded disc (or the video-
tape), press T-SET or
POWER first and then press
PLAY B or OPEN/CLOSE A
(or STOP/EJECT C/A).
• The unit will be turned on
automatically before the
recording time.
E9656UD_EN_1.qx4 05.7.15 11:55 AM Page 36